All about Denitrator

Originally Posted by Spakase

Any advantages of a coil denitrator?
Can the height of the denitrator be reduced so that you can have it stored inside the tank cabinet?
Bro Octane, you are using the denitrator on your aro tank! Do share with us the results. Is it a newly installed unit?

It is not a coil denitrator. It uses the same principle as those commercial unit.
Yes, the height can be reduce but it will lower down the processing capacity and thus the output flowrate will be reduce too.

[Koji™]

Originally Posted by atom

It is not a coil denitrator. It uses the same principle as those commercial unit.
Yes, the height can be reduce but it will lower down the processing capacity and thus the output flowrate will be reduce too.

I am thinking of doing a 6 feet long one. Dunno workable or not

Originally Posted by Koji™

I am thinking of doing a 6 feet long one. Dunno workable or not

1 moment to lazy to do. Next moment thinking of doing a gaint unit!

6 footer can but the diameter can increase to 10' and that going to be expensive for the end cap n screw cap (if you can find that size).

[Koji™]

Originally Posted by atom

1 moment to lazy to do. Next moment thinking of doing a gaint unit!

6 footer can but the diameter can increase to 10' and that going to be expensive for the end cap n screw cap (if you can find that size).

will have my way one la if I wanna do. Think need to do a circulating pump in there if not the water sure super stagnent

Originally Posted by Koji™

will have my way one la if I wanna do. Think need to do a circulating pump in there if not the water sure super stagnent

I always prefer to have a recirculating pump anytime!

[Koji™]

Originally Posted by atom

I always prefer to have a recirculating pump anytime!

Me too!! Same same thinking

Originally Posted by Koji™

Me too!! Same same thinking

What a relief! Nice to know that you know what I am driving at.

[Koji™]

Originally Posted by atom

What a relief! Nice to know that you know what I am driving at.

You're welcome

[silane]

Originally Posted by octane

initial value of 396mV, haha.. took quite sometime to hit -200mV

When the ORP value get lowered, that means the denitrator is working, right? Where do you insert the ORP probe?

[silane]

Originally Posted by atom

Till date, I am quite confident to achieve 20 l/hr and trying to do a 30 l/hr. To get close to zero, you will need to have 1 complete turnover a day......this means 1000/24=approx 42 l/hr. You might need 2 units of 1m tall denitrator to do that. There is a commercial unit that is this height, NR5000 from aquamedic.

How much would a NR5000 cost? It is cheaper to DIY?