CO2 Diffuser does not bubble evenly

Hi,

I just recently bought a CO2 diffuser. I just saw that the bubble is coming out from 5 tiny holes on one side of the large white surface.

Is there any way to make the bubble coming out from the round surface evenly?

Thanks!

I think it is quite common for it not to be so evenly distributed. If the pressure is not so strong then it will just come out from a few areas.

I only get a wider distribution when I have higher bps so the pressure will force it to come out from more pores.

I will try to increase the CO2 to utilize the diffuser area then decrease the CO2 again.